Chattanooga SENIOR SOLUTIONS, Руководство по обслуживанию

Страница: 71 / 108

66
Senior Solutions™ Therapy System
6 REMOVAL/REPLACEMENT
6.10 THERAPY SYSTEM STIM BOARD
CHANNELS 1/2
A. Tools and Equipment Required
#1 Phillips Screwdriver
Needle Nose Pliers
Flat Blade Screwdriver
B. Stim Board (Channels 1/2) Remova l
Remove Channel 3/4 Electrotherapy or NiMH
Battery if installed.
Refer to 6.2 part C for
instructions.
Remove sEMG Module if equipped.
Refer
to 6.3 part C.
Separate Top from Bottom. Refer to 6.4,
part B.
Remove Connector Board. Refer to 6.8,
part B.
Remove Ultrasound Board on Combination
Systems.
Refer to 6.9, part B .
Lay Therapy System on one side and use the
Flat Blade Screwdriver to remove the ¼ Turn
Fastener retaining the Stim Board in position.
See Figure 6.37.
Remove System to Module Ribbon Cable
from System.
See Figure 6.37A.
Gently pull up on each corner and release
the plastic retaining tabs holding the Stim
Board in position.
See Figure 6.38.
C. Replacing Stim Board
Replace new Stim Board, part number
27056, in reverse order of
steps 1-8 above.
Make certain Jumpers are properly set on
Stim Board.
See Figure 6.38A.
NOTE:
Position Ribbon Cable so the Blue Strip is
positioned as shown in
Figure 6.37A . Press
on Stim Board while seating Ribbon Cable to
the system. On Combination Systems, install
the Ribbon Cable and ¼ turn fastener before
installing the Ultrasound Board.
Re-assemble Therapy System.
Refer to
6.9 part C, 6.8 and 6.4, part C for proper
instructions.
NOTE:
Do not over-tighten the screws. Over-
tightening will damage the threads of the
brass inserts.
1.
2.
3.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
FIGURE 6.37
FIGURE 6.38
SLOT 90° TO
LOCKED INDICATOR
LOCKED
INDICATOR
RELEASE LOCKING TABS ON
EACH SIDE OF STIM BOARD
FIGURE 6.37 A
REMOVE
RIBBON CABLE
BLUE STRIP
FIGURE 6.38A
CHANNEL 3/4
POSITION
CHANNEL 1/2
POSITION
DISCONNECT THE SYSTEM FROM THE POWER
SOURCE (OUTLET OR REMOVE BATTERY MODULE IF
INSTALLED) BEFORE ATTEMPTING ANY MAINTENANCE,
INSTALLATION, REMOVAL, OR REPLACEMENT
PROCEDURES TO PREVENT ELECTRICAL SHOCK AND
POSSIBLE DAMAGE TO SYSTEM.