Install Bracket and CMK
3-5
3.2 Single Station with Cord Management
1.
Remove the ground lug by removing its two screws using a 3/8”
socket wrench (save the screws to reinstall in step 3 below).
2.
Connect the ground wire from the service wiring to the ground
lug, then run a 10-gauge ground wire from the ground lug through
the wiring opening in front of the pedestal.
3.
Reinstall the ground lug to the pedestal using the 3/8” wrench
and the two screws you removed.
4.
Run the remaining service wiring through the opening in front of
the pedestal.
5.
Slide the bracket over the pedestal. The two holes at the top and
two holes at the bottom of the bracket must align with the
corresponding holes in the pedestal.
