B-5
Installing onto a Stacked Parking Platform
Before installing the CPF25 onto a stacked parking platform, ensure that the site is suitable. Every stacked parking
platform is different. Therefore, instead of step-by-step instructions, ChargePoint provides the following
guidelines:
•
The CPF25’s Clean Cord Technology requires at least 2” between the rear edge of the mounting plate and the
wall to allow adequate clearance for the Cord Management Kit (CMK). Refer to the “Template, CPF25 Mount
Placement with Clearance” stapled into the center of this installation guide.
•
Before installing on the stacked parking platform, check to make sure that all pedestal mounting components
are readily available at the installation site.
•
Always check local codes to ensure compliance.
•
Ensure you have adequate wiring. Service wiring for the CPF25 must extend six feet above the platform’s
surface (just like any other type of CPF25 installation).
•
Refer to Section 2 of this installation guide for detailed instructions on how to install the pedestal mount. For
stacked parking installations, it is acceptable to use a service cord (i.e. jacketed cable) without conduit inside
the ChargePoint pedestal, provided the wiring is protected with appropriate bushings as it enters the
pedestal.
•
Ensure that the pedestal is stable and does not move excessively when the station is in use or when the
platform is in motion.
