4-1
Install Station(s) and Charging Cord(s)
4
Step 3: Mount the Station(s)
Follow these steps for each station:
•
Insert a 1/4” - 20 x 3/8”screw into the top center
hole on the front bracket using a #2 Phillips
screwdriver but leave the screw protruding
approximately 1/4” to create a 1/8” gap between
the back of the screw head and the bracket.
•
Position the mounting skirt against the back of
the main unit, as shown, and hold it in place while
hanging the main unit on the protruding top
screw.
•
Route the service wiring through the hole in the
back of the main unit.
•
Hang the main unit on the top protruding screw
on the bracket.
•
Secure the main unit by inserting the two 1/4” -
20 x 3/4” hex screws through the main unit (near
the bottom center) and into the bracket, as
shown. Tighten using a 3/8” hex driver.
1/4” - 20 x 3/8”screw (1)
1/4” - 20 x 3/4” hex screws (2)
