ChargePoint® Charging Stations
3-6
6.
Insert the four 1/4”-20 x 4" hex screws and lock
washers through the bracket and pedestal.
7.
Route the service wiring through the wiring hole
in the front of the bracket, as shown.
8.
Position the slot at the bottom of the CMK onto
the screw at the bottom of the pedestal and hold
the CMK against the back of the pedestal while
aligning the four 4” screws (inserted in the
previous step) into the corresponding holes in the
CMK.
NOTE:
The spacer on the pedestal should slide
into the ridges on the CMK.
9.
While holding the bracket and CMK in place, tighten the 4” screws into the CMK using the 7/16” socket.
You have now completed installation of the bracket and CMK and are ready to install the station and charging cord
as described in the Section 4.
1/4”-20 x 4" hex screws (4)
1/4” lock washers (4)
