Champion UH-200, Техническое руководство

Страница: 32 / 139

25
2.11Initial Start-up
(All Models)
Review Part 2, Installation, Sections 2.2 through 2.10, to ensure that all plumbing, electrical,
and chemical connections have been properly made by qualified personnel.
Plumbing connections are the proper size and supply pressures are correct.
• Water supply is on.
• Drains are correct size and functional.
Electrical power requirements and wiring connections are correct.
• Power is on at the main service panel.
Chemical Dispensing systems are installed and chemical supplies replenished.
• Detergent and rinse aid for Models UH-200B, UH-200.
Review Part 3, Daily Operation, Sections 3.1 through 3.5, for instructions on the operation
of your dishwasher, then perform the following checks for your model machine:
2.11.1 Models UH-200B, UH-200 (Initial Start-up)
Push the POWER button.
• 888F, and LED's flash on display
• No error codes (E0, E1, E2, E3)
• Machine fills
• Detergent pump runs (if applicable)
Open door and check water level in tank
• Water level at middle sensor of water level probe.
Probe located on interior left side of dishwasher.
• Close door.
• Check for leaks around dishwasher.
Run a cycle without dishes to bring the machine to operating temperature.
• 150
°
F/66
°
C
Push START button.
• Check for leaks.
• Dishwasher completes normal cycle.
• Final rinse temperature reaches minimum of 180
°
F/82
°
C.
Push POWER button.
• Displays flash 888F
• Dishwasher completes normal auto-shutdown cycle.
• Check for leaks in drain piping.
Part 2: INSTALLATION
√
√
√
(See next page)
√
√
√
√
√
Water Level Probe
Water
Level