Champion UH-200, Техническое руководство

Страница: 26 / 139

17
Part 2: INSTALLATION
2.9.1 General (All Models) Cont.
NOTE:
The detergent and rinse aid chemical dispensing pumps are optional equipment on
Models UH-200B and UH-200 dishwashers. The pumps may have been specified
when the dishwasher was ordered and installed at the factory.
The following instructions assume that your dishwasher was delivered to your
installation site with the dispensing pumps installed and explains the procedures for
placing the chemical dispensing system in service for the first time.
If optional pump(s) are not installed, Refer to Section 2.10, Installing Optional
Chemical Pumps, to install the chemical pump(s) before proceeding with
Section 2.9.2.
!! ATTENTION CHEMICAL SUPPLIER !!
WARNING:
The instructions contained in Section 2.9.2 require adjustments to the Fill/Chemical
Dispenser Circuit Board located inside the top mounted slide-out control cabinet.
When working on the dishwasher, disconnect the electrical service and place a red
tag at the disconnect switch to indicate work is being done on that circuit.
NOTE:
Refer to Part 7, Solid State Circuit Board Set-up and Repair, Section 7.3.5, page 58,
Fill/Chemical Dispenser Board, before making any adjustments to the dispenser
board settings.
.
Perform the following steps in preparation for making dispenser pump adjustments.
1. Loosen – do not remove – the (2) retaining screws at the bottom of the lower front access
panel. Lift the lower panel up and forward to remove.
2. Check for chemical dispensing pump(s) located at the front of the machine base.
3. Refer to Fig. 2.9.1.
Open the dishwasher door.
4. Locate the two screws, one in each corner
of the top hood, that retain the slide-out
control cabinet.
5. Remove the screws and pull the slide-out
cabinet forward to gain access to the
Fill/Chemical Dispenser Circuit Board.
(continued on next page)
Figure 2.9.1
Control Cabinet
Retaining Screws
FILL
/
CHEMICAL
DISPENSER BOARD