CENTURION SYSTEMS VERT-X, Руководство по механическому монтажу

Страница: 44 / 56

page 44 www.CentSys.com
10.3.3.2. Make Up and Mount the
Custom Bracket
For an outward swing installation,
the rear hinge point for the operator
needs to be on the inside of the
gate hinge. It may be necessary
to make up a custom bracket for
the installation if it is not possible
to mount the bracket to the wall
in the case where the side wall is
close enough to achieve the correct
A-Value. After determining the
correct position of the Wall Bracket in
Section 10.3.3.1., make up a custom
bracket that will securely hold the
Wall Bracket in this position as shown
in Figure 42A & 42B.
FIGURE 42A. MAKE-UP AND MOUNT CUSTOM
WALL BRACKET
FIGURE 43. CUT AND WELD THE WALL BRACKET
FIGURE 42B. MAKE-UP AND MOUNT CUSTOM
WALL BRACKET
B-Value
A-Value
Wall
Bracket
position
Gate Hinge
Centre Point
Typical Custom
Bracket
Typical Custom
Bracket
Mark length
on bracket
Weld the Wall
Bracket to the wall
mounting bracket
plate
Cut off
Excess Length
Wall Bracket
length
10.3.3.3. Cut, Weld and Mount the
Wall Bracket
Mark the determined length on the
Wall Bracket.
Measure the calculated
length from the centre of
the hole as indicated in
Figure 43.
Cut off excess length.
Insert the Wall Bracket into the
mounting plate.
Weld the brackets together.
OPERA
TOR
INS
TALLATION
-OUTW
ARD
OPENING
GATE
S
ECTION
1
0