CENTURION SYSTEMS VERT-X, Руководство по механическому монтажу

Страница: 19 / 56

page 19 www.CentSys.com
S
ECTION
6
PREPARATION
OF
S
ITE
FIGURE 5
1 metre
1 metre
Gate in closed
position
Gate hinge
point
Gate in open position
Mark the ground
Distance Z
Mark the ground
Wall
6.2. Determine Gate Opening Angle
Use this procedure to accurately determine the gate opening angle:
6.2.1. Step 1
Close the gate and measure a
distance of one metre from the
centreline of the gate hinge.
Make a mark on the ground.
6.2.2. Step 2
Open the gate and measure a
distance of one metre along the gate
from the centreline of the gate hinge.
Make another mark on the ground.
Measure the distance on the ground
between the two marks (Z).
Using this Z-Value, determine the
gate opening angle from the table
below.
Z-Value from To Use gate swing angle of
1000mm 1133mm 60° - 69°
1147mm 1272mm 70° - 79°
1286mm 1402mm 80° - 89°
1414mm 1475mm 90° - 95°
1486mm 1532mm 96º - 100º
Z-Values greater than 1532mm
1
TABLE 5
1. The VERT-X operator is designed for a maximum gate opening angle of 100°.
6.2.3. Step 3
Gate opening angle based on Z-Value