CENTURION SYSTEMS VERT-X, Руководство по механическому монтажу

Страница: 26 / 56

page 26 www.CentSys.com
Control
box
Mains
isolator
switch
FIGURE 17. CABLING REQUIREMENTS
Legend
1. 90V - 240V AC mains cable via mains isolator
1
switch (3 core LNE 0,5mm²)
2
,
or low-voltage 16V AC battery charger supply
3
(2 core 1,5mm²).
2. Intercom cable (n1 + 6 core) to house.
3. Master motor (MTR M) or Slave motor (MTR S) cable.
(Minimum, 2 core 1.5mm² + 4 core 0,22mm² multi-stranded)
4
.
4. Optional radio receiver cable (3 core 0,5mm² multi-stranded, optional)
5
.
5. Optional Pedestrian Keyswitch (2 core 0,5mm² multi-stranded) or optional keypad
(3 core 0,5mm² multi-stranded).
6. Optional, but recommeded Infrared Safety Beams (3 core 0,5mm² multi-stranded
or 4 core 0.5mm² for CE compliance).
7. Optional intercom cable (n2 + 2 core 0,5mm² multi-stranded) to gate station.
8. Optional electric lock (2 core 0.5mm²).
9. Optional Pillar Light cable (3 core, size according to power regulations).
10. Optional ground loop for free-exit (1 core 0.5mm² multi-stranded - silicone-coated)
6
.
• All cables must be routed in conduit unless underground cable is
being used
• Mains isolator must be less than one metre from the operator
• Safety Beams are always recommended
9
5
9
6
6
10
1
2
3
8
4
7
7. Cabling Requirements
1. As per SABS/IEC 10142 Electrical Regulations the mains isolator must be fitted less than 1.5m from the controller
2. Increase cable thickness if Pillar Lights are to be installed
3. Screened cable is always recommended to provide better protection against lightning - earth one end of screening
4. Please use V-Series cabling. Order reference: CABLEVEC68 (10M maximum from Vseries controller to operator)
5. For optimum range an external receiver can be mounted on the wall
6. Consult manufacturer of loop detector for specific details
S
ECTION
7
CABLING
REQUIREMENTS
350mm
cable loop