CENTURION SYSTEMS VERT-X, Руководство по механическому монтажу

Страница: 22 / 56

page 22 www.CentSys.com
6.6. Hinge Depth on Gate
Due to the operator body being a fixed length and the operator body extending past the
maximum travel position of the Gate Bracket pin , the operator can foul against the gate
during operation if the unit is not installed correctly. Before installing the operator, ensure
that the hinge depth in relation to the gate face is no more than 30mm.
This will ensure that the front end of the operator does not foul against the gate (see
Figure 9.)
A gate hinge depth greater than 30mm will reduce the E-value (refer to
Section 9) of the installation which, in turn, may result in the operator fouling
against the gate during operation. In the unlikely event that a hinge depth
greater than 30mm is measured (most gates will have a hinge depth of less than
30mm, with the exception of gates made from very thick material), the hinges
must be ground off and repositioned so as to ensure the hinge point is less than
30mm from the gate face.
FIGURE 8. MAXIMUM GATE HINGE DEPTH
Hinge centre
to gate face
(maximum 30mm)
Gate Hinge Point
Gate face
FIGURE 9. OPERATOR COLLIDING WITH GATE
Gate
VERT-X operator
Collision point
Hinge to gate face depth greater than 30mm
S
ECTION
6
PREPARATION
OF
S
ITE