Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
50
Producing readiness for operation
Set-Up
6 Set-Up
This chapter contains information on setting up the machine:
• Producing readiness for operation (page 50)
• Moving cutting shaft (page 52)
• Fitting and removing diamond saw blade (page 53)
• Removing and fitting blade guard (page 56)
• Converting machine (page 59)
• Commissioning (page 60)
6.1 Producing readiness for operation
• The machine is switched off and secured against accidental switch-on, see the chapter
"Operation" > "Daily shut-down" (page 72).
• Flat-blade screwdriver
WARNING
Danger to health caused by operating materials!
Some of the operating materials used are hazardous. In case of frequent contact with the
skin, there is a danger of developing cancer.
Avoid prolonged skin contact with the operating materials.
Always wear protective gloves during work.
ATTENTION
Environmental hazard caused by operating materials!
The operating materials used in the machine are hazardous to the environment!
Dispose of the operating materials used in accordance with the locally applicable legal
regulations.
Catch the escaping operating materials with suitable containers.
Prevent operating materials from getting into the soil.
Carry out the following steps:
1.
Release the
"
locking
tab
"
for the
"
SwivElling
holding
platE
"
.
2.
Move the
"
SwivElling
holding
platE
"
to the side.
3.
Open the
"
fuEl
rEfilling
opEning
"
.
4.
Check the fill level of the
"
fuEl
tank
"
.
?
There is insufficient diesel in the fuel tank.
Add diesel, see the chapter "Maintenance, repairs and shut-down" > "Refilling diesel"
(page 76).
5.
Close the
"
fuEl
rEfilling
opEning
"
.
6.
Move the
"
SwivElling
holding
platE
"
back.
Condition:
Required:
Check fill level of
fuel tank
