Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
59
Converting machine
Set-Up
6.5 Converting machine
The following sections contain information on converting the machine:
• The machine is switched off and secured against accidental switch-on, see the chapter
"Operation" > "Daily shut-down" (page 72).
• Spanner (13 mm)
• Spanner (17 mm)
• Allen key (10 mm)
Carry out the following steps:
Remove the fitted
"
diamond
Saw
bladE
"
if necessary, see the section "Removing dia-
mond saw blade" (page 56).
The diamond saw blade has been removed.
Carry out the following steps:
Remove the
"
bladE
guard
"
, see the section "Removing blade guard" (page 57).
The blade guard has been removed.
Carry out the following steps:
1.
Using the
"
SpannEr
"
(17 mm), unscrew the
"
faStEning
ScrEw
"
on the
"
viSor
dEvicE
"
.
2.
Carefully lift off the
"
viSor
dEvicE
"
.
3.
Swivel over the
"
viSor
dEvicE
"
.
4.
Using the
"
SpannEr
" (17 mm), retighten the
"
faStEning
ScrEw
"
on the opposite side.
The visor device has been swung over.
Condition:
Required:
Remove diamond
saw blade
Remove blade
guard
Swivel over
visor device
