Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
72
Daily shut-down
Operation
7.5 Switching off machine
• The machine is switched on, see the section "Switching on machine" (page 66).
Carry out the following steps:
1.
>Using the
"
crank
handlE
for
cutting
dEpth
adjuStmEnt
"
, lift the
"
diamond
Saw
bladE
"
out of the cut, see the chapter "Set-Up" > "Moving cutting shaft" (page 52).
!
Lift the diamond saw blade out of the cut until it is clear above the material to be cut.
2.
Move the
"
SpEEd
adjuStmEnt
lEvEr
"
into the - minimal position and hold it there.
The engine is then switched off.
The diamond saw blade runs on somewhat.
That's it!
7.6 Daily shut-down
Shut down the machine at the end of the shift.
• The machine is switched on, see the section "Switching on machine" (page 66).
Carry out the following steps:
Close the respective
"
watEr
valvE
"
.
The flushing water is shut off.
Condition:
Condition:
Shut off flushing
water
