Cedima 14102000 C, Перевод оригинального руководства по эксплуатации

Страница: 51 / 94

Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
51
Producing readiness for operation
Set-Up
7.
Fit the
"
locking tab
"
for the
"
SwivElling holding platE
"
.
The fill level of the fuel tank has been checked.
Carry out the following steps:
 Check the fill level of the engine oil using the
"
oil dipStick
"
.
?
Is there sufficient engine oil in the engine?

Add engine oil, see the chapter "Maintenance, repairs and shut-down" > "Refilling
engine oil" (page 78).
The fill level of the engine oil has been checked.
Carry out the following steps:

Check the
"
fuEl filtEr
"
and the
"
air filtEr
"
for cleanliness and proper operation.
The filters have been checked.
Carry out the following steps:
1.
Remove the
"
viEwing cap
"
from the
"
inSpEction opEning for
v-
bElt tEnSion
"
with the
"
flat
-
bladE ScrEwdrivEr
"
.
2.
Press the
"v-
bEltS
"
downward.
!
It must be possible to press the V-belts downward by a maximum of one finger's
breadth.
?
The V-belt tension is too tight or too loose?

Tension the V-belts, see the chapter "Maintenance, repairs and shut-down" > "Ten-
sioning V-belts" (page 79).
3.
Press the
"
viEwing cap
"
onto the
"v-
bElt tEnSion inSpEction opEning
"
again.
The tension of the V-belts has been checked.
Check fill level of
engine oil
Check filter
Check tension of
V-belts