CD3 Outpost, Руководство по эксплуатации продукта, Страница: 37 / 56

CD3 Products Manual
CD3, General Benefit Corporation | www.cd3station.com | stopais@cd3station.com | 612.467.9441
Patent
Pending | Made in USA | © 2019
37
4.2.2 Air Pressure Regulator
The air pressure regulator can be found attached to the inside of the unit frame near the
hose exit location. This is to the right side when accessing from the rear service door.
The air pressure regulator ensures that the air dispensed through the blow gun is at a
consistent and metered pressure of 90 psi at a maximum. The dispensing pressure
needs to be checked while the blow gun is dispensing air. The pressure at the gauge will
show slightly higher while the blow gun is not being operated. This setting should be
monitored for correctness because an incorrect pressure at the regulator could be a
symptom of another issue somewhere in the system. The pressure can be adjusted by
pulling up on the round black cap at the top of the regulator and rotating it clockwise to
increase pressure and counter-clockwise to decrease it.
Warning! - Do not modify the system to dispense air at any pressure exceeding 90 PSI.
4.2.3 Relief Valve
The relief valve can be found at the front of the compressor at the top, center of the
tank on the Station. It can be found at the top of the compressor sticking out the side of
the four-way fitting coming out of the top of the compressor on the Wayside units. Pull
the relief valve on a regular basis to ensure that it is operating properly and to clear the
valve of any possible obstructions. (See also maintenance schedule - sec. 4.9)
Station Wayside