CD3 Outpost, Руководство по эксплуатации продукта, Страница: 29 / 56

CD3 Products Manual
CD3, General Benefit Corporation | www.cd3station.com | stopais@cd3station.com | 612.467.9441
Patent
Pending | Made in USA | © 2019
29
smaller lever on top of the winch. Make sure that the winch small lever has been placed
in one of the locking positions (crank up or down position) prior to removing the clevis
pin. The lever not fully pushed to one side allows the winch to spin freely. This will
prevent the unit from lowering on its own due to its own weight. Once the clevis pin
has been removed, flip the small lever on the winch to allow the crank to be turned in
the direction that will lower the trailer and crank down. The unit should be lowered
until the front leveling legs come in contact with the ground. Follow the same
procedure for each of the cranks/winches behind the wheels. The winches behind the
wheels should be used alternating, lowering each a bit back and forth until the rear
leveling legs are in contact with the ground. Raise the unit using this procedure in
reverse. Raise the rear/wheel winches and install the pins before raising the
front/trailer tongue winch.
Front/Tongue Winch Rear Winch and Leveling Leg
3.7.4 Solar Panel Tie Down (Trailered Wayside Solar Only)
The solar panels should be secured before any travel with the trailered unit. High winds
can threaten the solar panel support structure under transport and should always be
secured with the provided solar panel retaining cover and straps prior to any
movement. The solar mesh cover attaches with a series of buckling straps across the
short direction and two straps across the long direction. The long side straps should be
encompassed by the shorter straps and all should be tightened as much as possible prior
to movement to prevent cover flapping in the wind.