SOHOSpeed ADSL2/2+ Ethernet/Wireless Gateway User’s Manual
93
3.8 Tools
The SOHOSpeed supports a host of tools which will allow you to customize and debug your
SOHOSpeed.
3.8.1 System
Commands
To make the changes permanent you need to click on
Tools
at the top of the page and select
System Commands
. The following commands are used to configure the SOHOSpeed:
z
Save all:
Press this button in order to permanently save the current configuration of the
SOHOSpeed. If you do re-start the system without saving your configuration, the
SOHOSpeed will revert back to the previously saved configuration.
z
Restart:
Use this button to re-start the system. If you have not saved your
configurations, the SOHOSpeed will revert back to the previously saved configuration
upon re-starting.
Note:
Connectivity to the unit will be lost. You can reconnect after the unit reboots.
z
Restart Access Point:
Use this button to restart the Wireless Access Point. It is
important to restart Access Point whenever you change your wireless settings.
z
Restore Defaults:
Use this button to restore factory default configuration.
Note:
Connectivity to the unit will be lost. You can reconnect after the unit reboots.
