SOHOSpeed ADSL2/2+ Ethernet/Wireless Gateway User’s Manual
35
4X
Enables/disables the 4x feature for 802.11g mode. This function is
SOHOSpeed proprietary and is only available when both TI wireless station
card and SOHOSpeed are used.
User Isolation
When checked, wireless users will not be able to directly access other
wireless users. More details on User Isolation are discussed in ‘‘User
Isolation’’.
QoS
Support Refer to ‘‘WLAN QoS Support’’ for more information.
User Isolation
When user isolation is enabled, wireless users will not be able to directly access other
wireless users. Access can be controlled by the AP.
The figure below illustrates the three states of enabling the user isolation feature:
1.
AP disabled basic service set (BSS) bridging: Before user isolation is enabled, the
stations can exchange data via the AP. This is disabled when user isolation is enabled.
2.
All data is sent to WAN.
3.
Enable/disable flag: No station has direct access to other stations as a result of user
isolation.
Follow the procedure below to save changes you have made on the Wireless Setup page.
1.
Click
Apply
.
2.
Click
Restart Access Point
at the bottom of the page, which takes you to the
System
Commands page
.
Note:
An alternative way to access the
System Commands
page is to select
Tools
at
the top of the page, then click the
System Commands
link.
3.
On the
System Commands
page, click
Save All.
This temporarily saves all the changes you have made. You will still need to restart the
access point for any changes to take effect.
4.
Click
Restart Access Point
for changes to the WLAN settings to take effect.
CAUTION:
Any changes you make to the WLAN page do NOT get saved automatically.
Clicking Apply on the individual page is not sufficient for the changes you made to take effect.
For changes you made to any WLAN page to take effect, you must perform the steps as
described above.
