SOHOSpeed ADSL2/2+ Ethernet/Wireless Gateway User’s Manual
19
Debug
Enables PPPoA connection debugging facilities. This allows the ISP
technical support and ODM/OEM testers to simulate packets going through
from WAN side.
For VLAN and PVC field descriptions, please refer to section 3.4.1.
Static Connection Setup
Static connection type is used whenever a known static IP address is assigned to the
SOHOSpeed. Additional addressing information such as the subnet mask and the default
gateway must also be specified. Up to three domain name server (DNS) addresses can be
identified. These servers resolve the name of the computer to the IP address mapped to it
and thus enable you to access other web servers by typing the symbolic name (host name).
1.
At the
Setup
main page, click
New Connection
.
The default PPPoE Connection Setup page is displayed.
2.
At the
Type
field select Static.
The Static Connection Setup page is displayed.
3.
In the
Name
field, enter a unique name for the Static connection.
The name must not have spaces and cannot begin with numbers. In this example, the
unique name is Static.
4.
The
Network Address Translation
(NAT) and the
Firewall
options are enabled by
default. Leave these in the default mode.
5.
In the
Static Settings
section, select the
Encapsulation
Type (LLC or VC).
Note:
If you are not sure, just use the default mode.
6.
Based upon the information your DSL/ISP provided, enter your assigned
IP Address
,
Subnet Mask
,
Default Gateway
(if provided), and
Domain Name Services
(DNS)
values (if provided).
7.
For the static configuration, you can also select a
Bridged
connection or a
Routed
connection.
8.
In the
PVC
Settings section, enter values for the
VPI
and
VCI
.
Note:
Your DSL service provider or your ISP supplies these values. In this example, the
DSL service provider is using 0,33.
9.
Select the
Quality of Service
(QoS). Leave the default value if you are unsure or if the
ISP did not provide this information.
The
PCR
,
SCR
,
MBS
, and
CDVT
fields are enabled/disabled depending on the
QoS
selection. Enter the values provided by the ISP or leave the defaults.
10.
Click
Apply
to complete the connection setup. This temporarily activates this connection.
A new link has been created for this connection in the left-hand column. You can apply,
delete, or cancel this connection using the buttons on this page.
