53
36. COMMAND CODE
The following commands are available when the balance is connected to a
peripheral device.
☞
For data format, see Section
35.
“
INPUT AND OUTPU DATA FORMAT.
”
If characters or control codes not described here are entered, normal
operation of the balance and correct weighing may be compromised. If
characters or control codes not described here are entered by mistake,
disconnect the power supply cable. Wait about 10 seconds and
reconnect it.
Command
code
Function
Contents
D01
Continuous output
The balance data is continuously
output at approximately every
230ms.
D05
One time output
Equivalent to the PRINT key.
D06
Automatic print
☞
See Section
11.
“
AUTO
PRINT.
”
D07
One time output with
stability information
S or U is output with the data to
indicate the stability state when
the measurement was taken.
S: Indicates the stability symbol
was illuminated.
U: Indicates the stability symbol
was not illuminated.
D08
One time output at the
stable state
After the stability symbol is
illuminated and the command is
entered, data is output.
D09
Output stop
Releases the automatic print and
continuous output functions.
Q
ON/OFF selection
Selection of STAND-BY state
and measuring state.
T
Taring
Equivalent to the
→
O/T
←
key
TS
Waiting for stability
Taring
Taring is conducted at the first
stable state after the command is
entered.
CAL or
C18
Span calibration
Initiates Span Calibration
+
Add Load Weighing
☞
See Section
13.
“
ADD LOAD
WEIGHING.
”
R
Total reset
End/Release of various
application weighing
g
g unit registration
mg
mg unit registration
PERCENT % unit registration
PCS
"Number of pieces"
registration
CT
"Carat" registration
☞
See Section
10.
“
REGISTRATION, RELEASE,
AND SELECTION OF
MEASUREMENT UNIT.
”
