Canon imageRUNNER ADVANCE C3500 III Series, Руководство по обслуживанию, Страница: 1045 / 1252

■ Checking the Network Connection
● Overview
If the user's network environment is TCP/IP, use the Ping
function to check that the network setting is properly
performed.
● Checking the Network Connection
CAUTION:
Be sure to use the network cable with Category 5e or
higher. In addition, a sealed type (STP cable) is
recommended.
Using the non-shield type can affect the peripheral
electrical equipment through the network cable.
1. Turn OFF the main power switch.
2. Connect the network cable to the Host Machine and
turn ON the main power switch.
3. Inform the system administrator at the installation
site that installation of the Host Machine is complete,
and then, ask for the network setting.
NOTE:
Network setting cannot be executed unless logging in as
an administrator. Factory default password is as follows.
• System administration division ID: Administrator
• System administration password: 7654321
CAUTION:
To perform the network setting, the following Additional
Functions items must be set "ON".
• [Additional Functions] > [Configuration] >
[Network] > [Confirm Network Connection Set.
Changes]
• [[Additional Functions] > [Configuration] >
[Network] > [TCP/IP Setting] > [IPv4 setting] >
[Use IPv4]
4. Turn OFF and then ON the main power.
● Operation Procedure Using Ping
1. Select the following: [Additional Functions] >
[Configuration] > [Network] > [TCP/IP setting] > [IPv4
setting] > [PING command]
2. Enter the IP address with the numeric keypad on the
Control Panel and press "Execute" key. "Response
from the host" is displayed if Ping command is
succeeded while "no response from the host" is
displayed if failed.
● Checking by the Remote Host Address
Using the remote host address to execute Ping can check
whether connection to the network is enabled or not.
Remote host address: IP address of PC terminal connected/
running on TCP/IP network environment that connects to this
equipment.
1. Inform the system administrator about checking of
the network connection using Ping.
2. Confirm the remote host address with the system
administrator.
3. Enter the remote host address to Ping.
• The network is properly connected if the message
say "Response from the host".
• The network is not properly connected if the
message say "No response from the host",
therefore, execute the following troubleshooting.
■ Network Troubleshooting
To check whether the network cable is properly connected to
the LAN Port.
● Operation Procedure Using Ping
1. Ask the network administrator at the user’s site to
write down the IP address of the PC that is
connected to the network.
2. [Additional Functions] > [Configuration] > [Network]
> [TCP/IP Setting] > [IPv4 setting] > [Ping
Command]; and enter the IP address of the PC with
the numeric keypad and press Execute key.
• The network is properly connected if the message say
"Response from the host".
• If the message say "No response from the host", check
the following.
NOTE:
The IP address of the PC can be checked by the following
procedure:
Select the following on a Windows PC: Start > Program >
Accessory > Command Prompt; and enter “ipconfig” and
press Enter key to display information of the IP address.
● Checking the Network Setting of the
Host Machine
1. Select the following: [Additional Functions] >
[Configuration] > [Network] > [TCP/IP Setting] >
[IPv4 setting] > [IP address setting]; and write down
the address in the IP address field.
2. Select the following: [Additional Functions] >
[Configuration] > [Network] > [TCP/IP Setting] >
9. Installation
1023