19
System 236E Installation Instructions
CL 1D - 23
Command Location 23: Door Chime Enable
2 3
0
0
0
0
0
0
(1) (2) (3) (4) (5) (6)
Default Values
Digit Position (1): Loop 1 Door Chime Enable
0 = No
1 = Yes: keypads beep two seconds when loop is faulted
Digit Position (2): Loop 2 Door Chime Enable
Refer to Digit Position (1) for programming options.
Command Locations 1D - 22: Loop Control
1 D
1
1
1
2
3
0
(1) (2) (3) (4) (5) (6)
Default Values
(Loop 1 defaults shown)
1D = Loop 1
1E = Loop 2
1F = Loop 3
20 = Loop 4
21 = Loop 5
22 = Loop 6
Digit Position (1): Loop Response Time
0 = 10 milliseconds
1 = 500 milliseconds
Digit Position (2): Loop Receiver Select
0 = Receiver 1 with Receiver 2 as back-up
1 = Receiver 1 only
2 = Receiver 2 only
3 = Receiver 1 and Receiver 2 (Dual Reporting)
Digit Position (3): Loop Restore Type
0 = No restoral
1 = Return to normal
2 = Return to normal, bell silences
3 = Return to normal, system disarmed
Digit Position (4): Loop Arming Type
0 = Instant
1 = Interior
2 = Delay
3 = Long Delay
4 = 24 hours (always armed)
5 = Keyswitch Arming (maintained)**
Digit Position (5): Loop Audible Type
1 = 3 Pulse Temporal
2 = Pulsing
3 = Steady
4 = Chirp
5 = Silent with no LED
6 = Silent with LED
Digit Position (6): Loop Circuit Type
0 = EOL: alarm on open or short
1 = Supervised: trouble on open; alarm on short; follows bell time
2 = Supervised, bell latched: trouble on open; alarm on short; bell latched
NOTE:
A Loop programmed as type 1 or 2 will report any
open as a Trouble condition, regardless of panel
armed status.
Digit Position (3): Loop 3 Door Chime Enable
Refer to Digit Position (1) for programming options.
Digit Position (4): Loop 4 Door Chime Enable
Refer to Digit Position (1) for programming options.
Digit Position (5): Loop 5 Door Chime Enable
Refer to Digit Position (1) for programming options.
Digit Position (6): Loop 6 Door Chime Enable
Refer to Digit Position (1) for programming options.
**
Only available on Loop 6. Digit Position (1) must be
programmed for 500 mSec with this option. Keyswitch
Arming reports as User #7.
7 = Ringback Enable *
*
Only available when Keyswitch Arming (Digit Position (4),
Option 5) is active. Bell will sound once when arming and
three times when disarming.
