Campbell NL200, Руководство пользователя

Страница: 43 / 64

C-1
Appendix C. NL200/201 Settings
All of the NL200/201 settings available from the Settings Editor in DevConfig are
described below.
C.1 Main Tab
Model (read only)
Model name.
Serial Number (read only)
Specifies the NL200/201 serial number assigned by the factory.
OS Version (read only)
Operating system version currently in the NL200/201.
Compile Date (read only)
Operating system compile date.
Bridge Mode
This setting is used to configure the device’s mode of operation.
Bridge Mode Disabled
With Bridge Mode disabled, the serial server (RS-232 or CS I/O), PakBus,
and secure proxy server functionalities are available. Refer to the respective
device settings for the configuration of these functionalities.
Bridge Mode Enabled
With Bridge Mode enabled, the device will act as a bridge from Ethernet to
CS I/O. All IP packets that come in to the device via Ethernet will be
communicated to a datalogger over the CS I/O port. Some filtering is done in
order to minimize the amount of traffic on the CS I/O port but every packet
that is transmitted to the datalogger is sent intact as a complete Ethernet/TCP
packet. This enables the datalogger to use its TCP/IP stack to interpret the
packet, and therefore, all of the datalogger’s TCP services are available. In
bridge mode, none of the other device settings are valid and all other
functionality is disabled. All settings (i.e., IP, netmask, gateway) are
configured in the datalogger.
When the device is configured in bridge mode, it is not possible to
configure it via TCP or open a telnet session with it. NOTE