Campbell NL200, Руководство пользователя

Страница: 33 / 64

User Manual
23
o
Input the IP Address, Network Mask, and Default Gateway. These
values can be provided by your network administrator.

On the Network Services tab:
o
Make note of the PakBus/TCP Server Port.
8.1.1 Configuring the Datalogger
The datalogger must first be configured for internet communication
(i.e., through an NL115, an NL120, a second NL200/201, or a
cellular modem).

Connect a serial cable from the PC COM port to the datalogger’s RS-232
port.

Open DevConfig. Select the device type of the datalogger (CR800, CR1000,
or CR3000), the appropriate Communication Port, and baud rate. Press
Connect to connect to the datalogger.

On the Network Services tab:
o
Under PakBus TCP Client Connections, input the NL200/201’s IP
address and PakBus TCP Server Port.

Press Apply to save the changes and then close DevConfig.
9. Troubleshooting
This section covers some common problems that might be encountered when
using the NL200/201. This is not comprehensive but should provide some insight
and ability to correct simple errors without a call to Campbell Scientific technical
support.
When your Campbell Scientific software cannot establish a link to a remote
datalogger that is connected to the NL200/201, do the following:
1. Check all your power connections.

Your NL200/201 and any hub and/or router being used must be
connected to power. Check power indicator lights to make sure your
devices are powered.
2. Check all your cables.

Verify that your Ethernet cable is securely plugged in between your
NL200/201 and your hub, router, or PC. The yellow Link/Act light on
the NL200/201 should start blinking when it is connected to the Ethernet.

If an Ethernet cable is connected but the Link/Act light is not blinking,
try a new Ethernet cable. You can also try moving the existing Ethernet
cable to a functioning system to determine if the cable is working.
3. Power cycle the NL200/201 and your hub/router/PC.

Turn off or unplug your hub/router/PC and NL200/201. Wait 10 seconds
and then plug them back in or turn them on. A full restart may take 30 to
60 seconds.
NOTE