Campbell NL200, Руководство пользователя

Страница: 13 / 64

User Manual
3

Ensure the NL200/201 is powered.

Connect the supplied USB cable between a USB port on your computer and
the USB port on the NL200/201.

Open Device Configuration Utility (DevConfig).

Under Device Type, select “NL200”.

Click the Browse button next to “Communication Port”.

Select the port labelled “NL200”.

Click OK.

Click Connect.

To enter a static IP address, select “disable” in the Use DHCP field. Then
input the IP Address, Network Mask, and Default Gateway. These values can
be provided by your network administrator.

If a dynamic address is to be used, the network information acquired via
DHCP can be seen on the NL200 tab.

Click Apply to save your changes.
It is recommended that a static IP address be given to the
NL200/201 for most applications so that the path to the device is
always known. If using a dynamic IP address acquired via DHCP
you may wish to configure the NL200/201 as a PakBus/TCP client.
3.3 LoggerNet Setup
The next step is to run LoggerNet and configure it to connect to the datalogger via
the NL200/201.

In LoggerNet’s Setup Screen, press Add Root and choose “IPPort”. Input the
NL200/201’s IP address and port number. The IP address and port numbers
are input on the same line separated by a colon. IPv6 addresses will need to
be enclosed in square brackets when specifying a port number. An IPv4
address may look like 192.168.1.100:6785. An IPv6 address may look like
[2001:db8::1234:5678]:6785. A fully qualified host name entry may look
like yourlogger.com:6785.

Add a PakBus Port (PakBusPort).

Add a PakBus Router (pbRouter). Input the PakBus address of the
NL200/201. The NL200/201’s default PakBus address is 678.

Add the datalogger and input the PakBus address of the datalogger.

Press Apply to save the changes.

You can verify that your settings are correct by selecting the datalogger in the
Network Map, selecting the Clock tab, and pressing Check Clocks. If your
settings are correct, you should see the current clock of your server and
datalogger.
NOTE