Campbell NL200, Руководство пользователя

Страница: 24 / 64

NL200/201 Network Link Interface
14
Figure 7-1. PakBus router LoggerNet setup
7.1.4 Connect
You are now ready to connect to your datalogger using the LoggerNet Connect
Screen.
7.2 Bridge Mode
7.2.1 Physical Setup
Using the supplied serial cable, connect the NL201’s CS I/O port to the
datalogger’s CS I/O port. Alternatively, power the NL200 or NL201 through the
barrel-connector jack located on the edge of the device. Connect the NL200/201
to your network using an Ethernet cable, attaching one end of the cable to the
NL200/201’s Ethernet port and the other end to your network. Ensure that the
device is powered up by inspecting the Power LED.
7.2.2 Configuring the NL200/201
Connect to the NL200/201 in DevConfig (see Section 6, Configuring the
NL200/201 ). In the NL200/201 tab, set Bridge Mode to “enable”.
7.2.3 Configuring the Datalogger

Connect a serial cable from the PC COM port to the datalogger’s RS-232
port.