CAB THARO Apollo Series, Руководство оператора

Страница: 75 / 139

75 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
10 Self Test / Test Print
Start of Test Print
To prepare a test print, load media (labels or continuous paper) which extends
over the entire print width of the Apollo.
If you want to perform the test print in thermal transfer mode, also use transfer
ribbon of the maximum width.
NOTICE !
During test print, the Apollo will not sense any label gaps. The length of
the printout will be about 9 in (230 mm). Endless paper would suit best
for test prints, otherwise, a normal sheet of A4 paper which is cut to a
width of 4.6 in (116 mm) can be used in thermal transfer mode.
To initiate a self test printout, press the key when switching on the
printer and keep it pressed down until the system test is completed.
The display shows "Test print", and the Apollo will print an internal test sample
which contains a variety of information about the configuration of the printer as
well as the results of the internal test.
The test printout can also include a range of hardware errors which have
occurred previously, even if they have disappeared again. This information is
important for service purposes and can only be deleted by Technical Support.
The information in the printout is also useful for checking the print quality, such
as differences in the blackness left/right, missing ink dots, etc. It is
recommended you carry out a print test immediately after receiving the printer.
After completing the test print, the Apollo will run the system test once again.
Then, the printer proceeds to ONLINE mode.
To cancel the test print press the key.
NOTICE !
The self test can also be carried out with the command "t" from the
ONLINE mode (see Programming Manual Apollo).