CAB THARO Apollo Series, Руководство оператора

Страница: 88 / 139

88 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Rewinding Directly onto the Rewind Axle
Fig. 13 d Rewinding directly onto the rewind axle
1. Position the rewinder in relation to the printer so that the label strip can run
cleanly and without hindrance from the printer to the rewinder.
2. Feed the label strip over the guide bar and under the roller onto the
rewinder axle (4) as shown in Figure 13 d.
3. Considering the required method of rewinding, attach the label strip appro-
priately to the rewinder axle (4) by sliding the clamp (5) over the label strip
with the clamp set in the groove. (the broken line shows the path of inside
rolled labels)
Ensure that the label strip is even with the disc (1).
4. Slide the clamp (5) as far as possible towards the disc (1).
5. Slide the flange (3) onto the rewind axle (4) so that it slightly touches the
label strip. The label strip must be able to move slightly between the disc
and the flange.
6. Tighten knurled screw (2) in the flange (3).
7. Switch the rewinder ON.
CAUTION !
When switched ON, the rewinder immediately starts rotating !
2 1
3
5 4