CAB THARO Apollo Series, Руководство оператора

Страница: 96 / 139

96 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Present Sensor
The optional present sensor in connection with printers with internal rewinder
allows for on-demand label dispensing. That means, the labels are removed
from the silicon liner immediately after printing, and then available in a dis-
pense position ready for further processing.
The present sensor (2) consists of two components, the dispense edge (19)
and the present sensor photocell (6). The presence of a label (20) in dispense
position is observed by the photocell. Through its connection to the peripheral
port of the Apollo, the signal pauses the print of the next label until the label in
the dispense position is removed.
NOTICE !
When editing or creating labels in demand mode, make sure that the part
of the label which lies directly underneath the photocell is only colored
(black) to a maximum of 50%. Higher blackening/ density print may cause
malfunctions of the sensor.
Fig. 13 n Mounting of the present sensor
The Apollo is generally shipped with the tear-off plate (1) mounted. When
operating in dispense mode, the tear-off plate has to be replaced with the
present sensor (2) :
1. Turn lever (4) counter-clockwise until it stops.
2. Remove the tear-off plate (1) from the mounting holes (3).
3. Slide the present sensor (2) into the mounting holes (3).
4. Turn lever (4) clockwise until it stops.
5. Connect the cable (5) of the present sensor (6) to the 15 pin peripheral port
of the Apollo.
4 3 5 6
2
1
Mounting of the Present Sensor