CAB THARO Apollo Series, Руководство оператора

Страница: 89 / 139

89 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
1. Use a cardboard roll (3) which is about .04 in (1 mm) wider than the label strip.
2. Position the rewinder in relation to the printer so that the label strip can run
cleanly and without hindrance from the printer to the rewinder.
3. Mount the first axle adapter (4) onto the rewinder axle (2) and slide it up to the
disc (1). Tighten knurled screw (5).
4. Mount the second adapter onto the rewinder axle (2). Slide it towards the first
adapter until the clearance between the edge of the adapter and the disc (1)
is a little less than the width of the cardboard roll (3). Tighten knurled screw
(5).
5. Slide the cardboard roll (3) over the two adapters (4) until it is touching the disc
(1).
6. Feed the label strip over the guide bar and under the roller as shown in Figure
13 e up to the cardboard roll (3).
7. Using adhesive tape or a label, affix the end of the label strip to the cardboard
roll (3). (the broken line shows the path of inside rolled labels)
8. Slide flange onto the rewind axle (2) until it stops at the cardboard. Tighten
knurled screw.
9. Switch the rewinder ON.
CAUTION !
When switched ON, the rewinder immediately begins rotating !
Fig. 13 e Rewinding onto 3 in (75 mm) cardboard cores
(view without flange)
Rewinding on to 3 in (75 mm) Cardboard Rolls
4 3 5
1 2