Chapter 3 How to Start Embroidery
BECS-528 Computerized Embroidery Machine's Manual
13
3-1-3 Descriptions of Menu Item's Status
The user interface of this computer has a lot of menus, which is quite practical. Usually,
the number of a menu item
（
such as
：①，②，③，。。。，⑩）
is displayed at the front of
that item, which is the serial number of the menu item. If the number is replaced by "
⊗
", the
menu item can not be entered. (The parameter is unavailable or invalid in the current setting.)
If a menu item has a “ ” before it, a password is needed to enter it.
3-1-4 How to Embroider for the First Time?
The machine embroiders according to the design in memory. Before using the machine for
the first time, user needs to initialize the parameters in the system (please refer to Chapter 9-7)
and then clear the memory (this operation involves the “Pattern Management”, please refer to
Chapter 10-10 Memory Pattern Management). After that, user can input the patterns needed via
the disk. After the patterns are input, user can select a pattern in memory and confirm it for
embroidery. Now, the machine goes into confirmation status. Finally, user can pull the
embroidery bar to right to start embroidering the pattern.
3-2 Input a Design into Memory from Disk
Load pattern into memory from disk can be performed in the menu of “Memory Pattern
Management”
User can input the disk pattern by using USB disk from USB port or using floppy disk
through the floppy driver at USB port. The system has only one USB port, so it can be
connected one floppy disk or one USB disk. You can insert or draw floppy/USB disk directly.
1.Press "
" key. Press move the icon to "Disk Design into Memory", and then press
"
" key.
2.Select a disk pattern and press "
" key.
