burmeier Regia, Инструкция по эксплуатации

Страница: 60 / 152

3.6.1 No safety sides (standard)
3.6.2 Full-length safety sides (DSG)
3.6.2.1 Installation
CAUTION
The use of full-length safety sides is only possible with head and footboards that have in-
tegrated guide profiles.
This bed is delivered as standard without any safety sides.
The bed can be equipped with full-length safety sides at the customer’s request to protect the
resident from accidentally falling out of bed. The safety sides are made of bars with plastic
end caps and are attached to the bed with a simple click-on system. Whenever the safety
sides are needed, they can be raised or lowered by hand by carers or relatives. Each head-
board and footboard is fitted with a guide rail on the right and left-hand side. There is a safety
side guide in each of these with two fixtures for holding the safety side bars. The safety side
guides are pre-assembled at the factory. The safety side bars can be attached to the holding
devices quickly and with little effort thanks to the simple click-on system.
Risk of injury
Failure to heed this warning may result in injury and damage to property due to improperly
assembled, falling safety side bars.
•
After installing each safety side bar, check that it is correctly locked into the holding devi-
ces.
•
Test the function to check that the safety sides are correctly fitted. For more information
on operating the safety sides, see chapter
Part C: Safety sides
»
20 .
Important: The holding devices must be diagonal to each other before starting the assembly
work (see picture). To ensure this, raise the holding device at the head end and lower the
holding device at the foot end.
1. Start with the headboard on the right-hand side of the bed and proceed as follows: At-
tach one end of the wooden safety side bar to the holding fixture [1].
• Please note: The recess on the safety side bar must face inwards and the roun-
ded side of the bar must face upwards.
Assembling the Care Bed
24 Part B: Operator and Technical Personnel