Burkert Flowave 8098, Руководство по эксплуатации

Страница: 69 / 354

69
Electrical installation
Type 8098 FLOWave L
8.16 Knowing the status of the Ethernet network (device
variant with two 4-pin M12 female connectors –
Ethernet device variant)
The status of the Ethernet network is indicated by LEDs. The LEDs are located on the industrial communi -
cation module in the transmitter housing.
→
To see the LEDs, open the front of the transmitter housing by removing either the blind cover or the
display module or the Wi-Fi module; see chapter 8.9.
Interface X2
(Ethernet Port Switch):
Link/Act LED (green)
Link LED (yellow)
Connection to the PLC:
Error LED (yellow)
RUN LED (green)
X1 X2
Interface X1
(Ethernet Port Switch):
Link LED (yellow)
Link/Act LED (green)
Fig. 35: Status LEDs for the industrial communication module
Description of the LEDs:
Table 17: Status LED for the connection to the PLC
LED status Connection status What to do?
RUN LED (green) Error LED (yellow)
ON OFF Connection active. -
OFF ON Connection not active. Check cables
Table 18: Status LEDs for the connection to the Ethernet network
LED status Connection status What to do?
Link/Act
LED
(green)
ON Rapid flashing: connection to the higher-level pro -
tocol layer EtherNet/IP has been established. Data
is being transmitted.
Slow flashing: there is no connection to the pro -
tocol layer. This is usually the case for approx.
20 seconds following a restart.
-
OFF No connection to the network is available. Check cables
Link LED
(yellow)
ON Connection to the network is available. -
OFF No connection to the network is available. Check cables
English