Burkert Flowave 8098, Руководство по эксплуатации

Страница: 284 / 354

284
SAW sensor – Maintenance
Type 8098 FLOWave L
17.27.2 Checking the behaviour of the device by simulating an event
The events Low flow cut off and Backward flow can only be tested by simulating a flow rate value.
See chapter 17.27.1 .
To check the behaviour by simulating one or several events that are enabled on the device, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Go to the
MAINTENANCE
view.
→
Simulation
→
Status
→
Running
→
Diag. events
→
Choose
Process
or
Electronic
or
Sensor
→
Choose the events to be simulated
→
Check if the device behaves depending on the settings you have made.
The simulation is active as long as the status Running is active. Thus, you can:
• leave the menu to check if the simulated events have been generated (see chapter 16.8 Reading out the
diagnostics events that occurred in the process , chapter 16.9 Reading out the diagnostics events that
occurred on the electronics and chapter 16.10 Reading out the diagnostics events that occurred on the
sensor),
• or simulate one or several events.
→
To stop the simulation, see chapter 17.27.3 Stopping the simulation of process values and events .
English