Burkert Flowave 8098, Руководство по эксплуатации

Страница: 152 / 354

152
SAW sensor – Parameter
Type 8098 FLOWave L
→
As an alternative to the 3 predefined damping levels Low , Medium or High , you can set your own
damping parameters. See chapter 15.4.3 .
None damping: all
the fluctuations of the
measured values are
transmitted
Low damping Medium damping High damping
Chosen damping level is applied
No damping if 2 consecutive measured values vary for ±30 %
Fig. 51: Operation of the available damping levels
Table 24: Response times (10 %...90 %) of the damping levels for the volume flow rate measurements
Damping level Response time
None • 5 s if the Refresh time is set to Long
• < 0.5 s if the Refresh time is set to Short or Very short.
Low 1 s
Medium 10 s
High 30 s
Special User-defined
Response time
: see chapter 15.4.3
To set a predefined damping level of the measured volume flow rate values, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the
Parameter
view.
→
Stand. meas. values
→
Volume flow
→
Damping The Current settings are displayed
→
Choose a damping level between Low , Medium and High The New settings are
displayed.
→
Save.
The damping of the volume flow rate values is active and a predefined damping level is chosen.
English