Burkert Flowave 8098, Руководство по эксплуатации

Страница: 59 / 354

59
Electrical installation
Type 8098 FLOWave L
On a device with two 4-pin M12 female connectors (Ethernet device variant), do not use terminals
6 to 12.
• Terminal 6: GND (for the connection of the power supply through the M20x1.5 cable glands)
• Terminal 7: negative output 3 (analogue output or digital output)
• Terminal 8: positive output 3 (analogue output or digital output)
• Terminal 9: negative output 2 (digital output)
•
Terminal 10: positive output 2 (digital output)
• Terminal 11: negative output 1 (analogue output)
• Terminal 12: positive output 1 (analogue output)
Fig. 25: Terminal assignment of the 12 push-in terminal strip located in the transmitter housing
8.9 Opening the front of the transmitter
To open the front of the transmitter housing, remove either the blind cover or the display module or the
Wi-Fi module.
Procedure to open the front of the transmitter if the blind cover is on the front of the device
1. Put the magnetic key on the mark related
to the blind cover. You should hear a click indi-
cating that the blind cover is unlocked. Do not
use a tool to turn the blind cover.
2. Turn the blind cover by hand to the unlocked
position and remove it.
Fig. 26: Procedure to open the front of the transmitter if the blind cover is on the front of the device
English