Bull Cedoc Bullx R423-E3, Инструкция по установке и эксплуатации

Страница: 58 / 98

6.4 Drive Bay Installation/Removal
6.4.1 Accessing the Drive Bays
SAS/SATA Drives: You do not need to access the inside of the chassis or remove power to
replace or swap SAS/SATA drives. Proceed to the next step for instructions. You must use
standard 1" high, SAS/SATA drives in the system .
You must use standard 1" high, SAS/SATA drives in the system.
DVD-ROM: For installing/removing the DVD-ROM drive, you will need to gain access to
the inside of the server by removing the top cover of the chassis. Proceed to the "DVD-
ROM Installation" section later in this chapter for instructions.
WARNING
Enterprise level hard disk drives are recommended for use in Bull’s chassis and servers.
6.4.2 SAS/SATA Drive Installation
These drives are mounted in carriers to simplify their installation and removal from the
chassis. The carriers also help promote proper airflow for the drives. For this reason,
even empty carriers without hard drives installed must remain in the chassis.
Removing a Drive Carrier
1. Push the release button located beside the drive's LEDs .
2. Swing the handle fully out and use it to pull the drive carrier straight out (see Figure
6-3) .
Mounting a Drive in a Drive Carrier
1. To add a new SAS/SATA drive, install the drive into the carrier with the printed circuit
board side facing down so that the mounting holes align with those in the carrier .
2. Secure the drive to the carrier with four screws, as shown in Figure 6-4 .
Note Your operating system must have RAID support to enable the hot-plug capability of the
drives.
48 bullx R423-E3 - Installation and User's Guide