Bull Cedoc Bullx R423-E3, Инструкция по установке и эксплуатации

Страница: 75 / 98


SATA Configuration
When this submenu is selected, the AMI BIOS automatically detects the presence of IDE or SATA
devices and displays the following items.
SATA Port0~SATA Port5 : The AMI BIOS displays the status of each SATA port as detected by the
BIOS.
SATA Mode
Use this feature to configure SATA mode for a selected SATA port. The options are Disabled, IDE
Mode, AHCI Mode and RAID Mode. The following are displayed depending on your selection:
IDE Mode
The following items are displayed when IDE Mode is selected:
Serial-ATA (SATA) Controller 0~1
Use this feature to activate or deactivate the SATA controller, and set the compatibility mode.
The options for Controller 0 are Enhanced and Compatible. The default of SATA Controller 1
is Enhanced.
AHCI Mode
The following items are displayed when the AHCI Mode is selected:
Aggressive Link Power Management
When Enabled, the SATA AHCI controller manages the power usage of the SATA link. The
controller will put the link in a low power mode during extended periods of I/O inactivity, and
will return the link to an active state when I/O activity resumes. The options are Enabled and
Disabled.
Port 0~5 Hot Plug
Select Enabled to enable hot-plug support for a particular port, which will allow the user to
change a hardware component or device without shutting down the system. The options are
Enabled and Disabled.
Staggered Spin Up
Select Enabled to enable Staggered Spin-up support to prevent excessive power consumption
caused by multiple HDDs spinning-up simultaneously. The options are Enabled and Disabled.
RAID Mode
The following items are displayed when RAID Mode is selected:
Port 0~5 Hot Plug
Select Enabled to enable hot-plug support for the particular port. The options are Enabled and
Disabled.
Chapter 7. BIOS 65