Bull Cedoc Bullx R423-E3, Инструкция по установке и эксплуатации

Страница: 22 / 98

3.3 Control Panel LEDs
The control panel located on the front of the chassis has several LEDs. These LEDs
provide you with critical information related to different parts of the system. This section
explains what each LED indicates when illuminated and any corrective action you may
need to take .
 Power Fail: Indicates a power supply module has failed. The second power supply
module will take the load and keep the system running but the failed module will
need to be replaced. Refer to Chapter 6 for details on replacing the power supply.
This LED should be off when the system is operating normally .

Information LED: This LED will be solid blue when the UID function has been
activated. When this LED flashes red, it indicates a fan failure. When red
continuously it indicates an overheat condition, which may be caused by cables
obstructing the airflow in the system or the ambient room temperature being too
warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers are
installed. Finally, verify that the heatsinks are installed properly (see Chapter 5). This
LED will remain flashing or on as long as the indicated condition exists .

NIC1: Indicates network activity on the LAN1 port when flashing .
 NIC2: Indicates network activity on the LAN2 port when flashing .
12 bullx R423-E3 - Installation and User's Guide