Bull Cedoc Bullx R423-E3, Инструкция по установке и эксплуатации

Страница: 52 / 98

JLAN1/JLAN2 Enable/Disable
Use JPLAN1 to enable/disable LAN Ports
1/2. See the table on the right for jumper
settings. The default setting is Enabled .
Watch Dog Enable/Disable
Jumper JWD controls the Watch Dog
function. Watch Dog is a system monitor
that can reboot the system when a software
application hangs. Jumping pins 1-2 will
cause WD to reset the system if an
application hangs. Jumping pins 2-3 will
generate a non-maskable interrupt signal
for the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in BIOS .
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on
the right for jumper settings .
BMC Enable
Jumper JPB1 allows you to enable the
embedded the Winbond BMC
(Baseboard Management) Controller to
provide IPMI 2.O/KVM support on the
serverboard. See the table on the right for
jumper settings .
SAS Enable/Disable
Jumper JPS1 allows you to enable or
disable the onboard SAS connections. The
default setting is Enabled. See the table on
the right for jumper settings .
I
2
C Bus to PCI-Express Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to
connect the System Management Bus (I
2
C)
to the PCI-Express slots. The de- fault setting
is Disabled. Both jumpers must be set to the
same setting See the table on the right for
jumper settings .
42 bullx R423-E3 - Installation and User's Guide