Bryant CONDENSING GAS FURNACE 352MAV Скачать руководство пользователя

Страница: 7 / 52

tube is used to extend the condensate trap drain connection to the
desired furnace side for field drain attachment. See Condensate
Trap Tubing (Factory-Shipped Orientation) section for drain tube
extension details. (See Fig. 5.)

Condensate Trap Tubing (Factory-Shipped

Orientation)

NOTE:

See Fig. 6 or tube routing label on main furnace door to

confirm location of these tubes.

1. Collector Box Drain, Inducer Housing Drain, Relief Port,

and Pressure Switch Tubes.
These tubes should be factory attached to condensate trap
and pressure switch ready for use in upflow applications.
These tubes can be identified by their connection location
and also by a color label on each tube. These tubes are
identified as follows: collector box drain tube (blue label),
inducer housing drain tube (violet label or molded), relief
port tube (green label), and pressure switch tube (pink
label).

2. Condensate Trap Drain Tube.

The condensate trap drain connection must be extended for
field attachment by doing the following:

a. Determine location of field drain connection. (See Fig. 2

or 6.)

NOTE:

If internal filter or side Filter/Media Cabinet is used, drain

tube should be located to opposite side of casing from return duct
attachment to assist in filter removal.

b. Remove and discard casing drain hole plug button from

desired side.

c. Install drain tube coupling grommet (factory-supplied in

loose parts bag) in selected casing hole.

d. Slide drain tube coupling (factory-supplied in loose parts

bag) through grommet ensuring long end of coupling
faces blower.

e. Cement 2 factory-supplied 1/2-in. street CPVC elbows to

the rigid drain tube connection on the condensate trap.
(See Fig. 6.) These elbows must be cemented together
and cemented to condensate trap drain connection.

NOTE:

Failure to use CPVC elbows may allow drain to kink and

prevent draining.

f. Connect larger diameter drain tube and clamp (factory-

supplied in loose parts bag) to condensate trap and clamp
securely.

g. Route tube to coupling and cut to appropriate length.

h. Attach tube to coupling and clamp securely.

Condensate Trap Location (Alternate Upflow

Orientation)

An alternate location for the condensate trap is the left-hand side
of casing. (See Fig. 2 and 7.)

NOTE:

If the alternate left-hand side of casing location is used,

the factory-connected drain and relief port tubes must be discon-
nected and modified for attachment. See Condensate Trap Tubing
(Alternate Upflow Orientation) section for tubing attachment. To
relocate condensate trap to the left-hand side, perform the follow-
ing:

1. Remove 3 tubes connected to condensate trap.

2. Remove trap from blower shelf by gently pushing tabs

inward and rotating trap.

Fig. 6—Factory-Shipped Upflow Tube Configuration

(Shown with Blower Access Panel Removed)

A01030

COLLECTOR BOX

TUBE (PINK)

COLLECTOR BOX

TUBE (GREEN)

INDUCER HOUSING

(MOLDED) DRAIN