SL-746A, 748A
56
Problem
Possible cause
Page
51
19
51
–
19
–
44
47
45
30
26
13. TROUBLESHOOTING
12. Broken needles
¡
Is the material being pushed or pulled with excessive force during
sewing?
¡
Is the needle properly installed?
If it is incorrect, install the needle correctly.
¡
Is the needle bent, is the needle tip broken, or is the needle hole
blocked?
Replace the needle.
¡
Is the needle and rotary hook timing incorrect?
Adjust the height of the needle bar.
Adjust the clearance between the needle and the rotary hook.
¡
Is the needle timing advanced too far with respect to the feed dog?
Retard the needle timing.
Caution
¡
It is extremely dangerous to leave any pieces of broken needle
sticking in the material. If the needle breaks, search for all pieces
until the whole of the needle is found again.
¡
Furthermore, we recommend that through steps be taken to ac-
count for such needles to comply with product liability regula-
tions.
13. The thread wiper does
not wipe the thread.
(748A-40
䡺
, 90
䡺
, option)
¡
Is the length of thread trailing from the needle hole too long after
thread trimming?
Adjust the pretension.
¡
Is the stitch length longer than 5 mm?
Is a upper thread which is thick or fluffy being used?
In such cases, use a needle plate with groove.
10. Incorrect thread trimming
(upper and lower threads
are both not being
trimmed). (748A)
¡
Is the fixed knife or movable knife damaged or worn?
Replace the fixed knife or the movable knife.
11. Incorrect thread trimming
(upper thread or lower
thread is not being
trimmed). (748A)
¡
Is the needle properly installed?
If it is incorrect, install the needle correctly.
¡
Is the fixed knife or movable knife blunt?
Replace the fixed knife or the movable knife.