Brother PD-3000, Инструкция по эксплуатации

Страница: 43 / 210

CHAPTER 3 PROGRAMMING WITH ICONS
PD-3000 35
Double stitch
Use “double stitch” to program two parallel lines. The following describes how to program the double stitch to the left
of the sewing direction .
Be sure to press twice to make a split at a point B or E where the line changes to the curve. Placing more
intermediate points such as points C and D creates smoother curves.
1. Carry out steps 1 to 3 of "Procedure for
programming with icons".
2. Select with , and then press
.
3. Select a double stitch type with ,
and then press .
In this example, select and press .
For double stitch types, refer to "Creating double stitch"
(page 67).
4. Select where a double stitch is created, on the
right or left of the sewing direction, with ,
and then press .
When creating it on the left side, select .
5. Input the stitch length and width, and then press
.
Input "030" to make the stitch length 3.0 mm.
To switch input between the stitch length and the
width, use
.
6. Move the work clamp with .
Press twice for a split when the needle
point is at point B of the pattern sheet.
7. Program points C, D and E.
8. When point E is programmed, press again
for a split.
9. Program point F.
10. When point F is programmed, press .
11. Press .
The needle moves to points F, G and H.
12. When the needle stops, press three times.
13. Carry out steps 5 to 7 of “Procedure for
programming with icons”.
Sewing
width
Sewing
direction