Brother HL-2060, Руководство по обслуживанию

Страница: 92 / 147

VI-10
I-13 Faulty registration
Possible cause Step Check Result Remedy
Top margin
setting error 1 Does self test printing have no problem? Yes Check again the top
margin setting in the
printing data.
Paper load in
the cassette 2 Is over-amount of paper than specified load
on the cassette? Yes Reduce the paper load
below the specified limit.
Paper failure 3 Does print quality improve when
recommended paper is used? Yes Use recommended paper.
Paper failure 4 Is paper curled? Yes Use recommended fresh
paper without curl.
Improper Y
offset setting 5 Does print quality improve when Y offset
setting is changed? Yes Adjust Y offset setting to
an appropriate value.
Jam remove
cover failure 6 Is the jam remove cover deformed? Yes Replace the jam remove
cover.
Failure in regist
sensor actuator
motion 7 Does the regist sensor actuator operate
smoothly? No Reassemble the actuator
and, if the problem is not
resolved, replace the
actuator.
Regist sensor
failure 8 Is the voltage at the pin 5 of the connector P3
of the main PCB 5V when no paper passes
and 0V when paper passes? No Replace the paper
feed/size-sw PCB assy or
the harness and, if the
problem remains, replace
the main PCB assy.
Paper feed roller
failure Yes Replace the paper feed
roller assy.
I-14 Poor fixing
Possible cause Step Check Result Remedy
Fixing unit
release spacer
not removed 1 Is the fixing unit release spacer removed? No Remove the fixing unit
release spacer.
MEDIA TYPE
setting 2 Is the MEDIA TYPE set to TRANSPARENCY? Yes Set the MEDIA TYPE to
REGULAR or THICK
PAPER.
Paper failure 3
Is thick paper over than 36lb (135g/m
2
) used?
Yes Instruct the user to use
the paper whose
thickness is less than the
recommended value.
Thermistor
failure 4 Is the voltage at the pin 3 of the connector
P11 of the main PCB is controlled within
1.80 ± 0.10V during continuous printing? No Replace the fixing unit.
Fixing unit
failure Yes Replace the fixing unit.