Brother HL-2060, Руководство по обслуживанию

Страница: 34 / 147

III-1
CHAPTER III ELECTRICAL SYSTEM
Electric signal levels are expressed by “High” (approximate the supply voltage) or “Low”
(approximate 0V). Signals with hyphen or slash, such as -FSRD or FSRD/, are low-active
and signals without hyphen or slash, such as FSRD, are high-active signals.
1. MAIN PCB
1.1 Outline
The Main PCB consists of the Video Controller Circuit and the Engine Controller Circuit.
The Video Controller Circuit performs the following functions.
(1)
Converts data received from an external device, such as a personal computer,
through Centronics parallel interface or RS-232C serial interface into video data
and transfers it to the Engine controller circuit.
(2) Displays the current printer status in LED and LCD, and enables settings from the
control panel.
The operation sequence of the printer controlled by a microprocessor in the Engine
Controller Circuit. The Engine Controller Circuit outputs signals to drive the various loads
on the laser diode, laser unit motor, main motor, etc. according to the print commands
and image data from the external device.
IC CARD
(PCMCIA)
MIO BOARD
Regurator
+24V
PC
PC
CDCC (bolse) IF
RS-232C IF
ASIC
MB87F1611
Video controller
Engine controller
Engine CPU
M38063
+24V
+5V
GND
CONTROL PANEL
Low-voltage
Power Supply
Gate Array
µPD65632GF-
(IO PORT. ENGINE)
MASK ROM
32M mask 2 4MB
DRAM
16M 4 8MB
DRAM (SIMM 2 slots)
64MBmax.
EEPROM
24CO4 4Kbit
Main CPU
MB86832
Main PCB
MIO RELAY
(CONNECTOR)
PCB
PC
USB IF
IC CARD
(PCMCIA)
Figure 3.1 Main PCB Block Diagram