Brother DCP-2537DW, Руководство по обслуживанию

Страница: 281 / 340

5-9
Confidential
<Operating Procedure>
(1) Press the [1], and then the [0] in the initial state of maintenance mode. For models
without keypad, press the [ ▲ ] or [ ▼ ] to display “MAINTENANCE 10” on the LCD and
press the [OK]. “WSW00” is displayed on the LCD.
(2) Enter the worker switch number that you want to change the setting. For models without
keypad, press the [ ▲ ] or [ ▼ ] to display the worker switch number for which you want to
change the setting on the LCD and press the [OK].The following display appears on the
LCD.
(3) Press the [ ◄ ] or [ ► ] to move the cursor to the desired selector, and change the setting
by pressing the [1] or [0]. For models without keypad, pressing the [ ▲ ] enters “1” and
pressing the [ ▼ ] enters “0”. Press either to enter desired number to Selector No.1. The
next digit starts flashing. Keep entering numbers to Selector No.8 using the [ ▲ ] or [ ▼ ].
(4) When changing the setting is completed, press the [SET] or [OK]. The new selector
setting value is stored in the EEPROM, and the LCD returns to the ready state for worker
switch number entry (“WSW00”).
(5) When all switch setting is completed, press the [X] or [Stop] to return the machine to the
initial state of maintenance mode.
WSW
No.
Function
WSW
No.
Function
WSW71 Change of the setting is prohibited WSW85 Function setting 29
WSW72 Change of the setting is prohibited WSW86 Change of the setting is prohibited
WSW73 Change of the setting is prohibited WSW87 Change of the setting is prohibited
WSW74 ADF stop control WSW88 Detection of the threshold of
remaining T1 amount
WSW75 Switch back ejection distance
WSW76 Set the limit for the number of
documents to be ejected in
reverse order for single-side
scanning from ADF WSW89 Change of the setting is prohibited
WSW90 Detection of the threshold of
remaining T2 amount
WSW91 Change of the setting is prohibited
WSW77 Set the limit for the number of
documents to be ejected in reverse
order for duplex scanning from ADF WSW92 Change of the setting is prohibited
WSW93 Detection of the threshold of
remaining T3 amount
WSW78 Recording stop function when
the drum reaches the end of life WSW94 Detection of the threshold of
remaining T4 amount
WSW79 Function setting 28 WSW95 Detection of the threshold of
remaining T5 amount
WSW80 Copying speed control function
WSW81 Changing emulation function
enable/disable setting WSW96 Change of the setting is prohibited
WSW82 AirPrint Icon No. setting WSW97 Font type in Remote Setup display
WSW83 Change of the setting is prohibited WSW98 Function setting 29
WSW84 Change of the setting is prohibited WSW99 Change of the setting is prohibited
Note:
• To cancel operation and return to the initial state of maintenance mode, press the [X] or
[Stop].
• If there is no entry for one minute or longer on 2-digit worker switch number selection after
the first digit was entered, the machine returns to the initial state of maintenance mode
automatically.
Selector No.1 Selector No.8