Boston Whaler 280 Dauntless, Руководство пользователя, Страница: 71 / 163

3-1
Chapter 3 • Systems Overview and Operation
R
280 Dauntless
Ensure continuous visibility of other boats,
swimmers and obstacles during bow-up
transition to planing. Adjust engine to an
intermediate trim as soon as boat is on plane
to avoid possible ejection due to boat spinout.
Do not attempt to turn boat when the engine is
trimmed extremely down, under or in.
NOTICE
Shift controls into neutral before starting engine.
Shift only when engine is at idle. Reversing at
high speeds can cause flooding/swamping due
to water being pushed over the transom.
!
CAUTION
Wind and sea currents can change how this
vessel responds while in motion. Understanding
this vessel and its reactions at speed will make
boating safer and more enjoyable.
NOTICE
Boat Start-up
!
CAUTION
Never start or operate engine(s) (even
momentarily) without water circulating
through all the cooling water intake holes in
the gear case to prevent damage to the water
pump (running dry) or engine overheating.
Pre-start Check
Operator should know boating safety, safe navigation,
and safe boat operating procedures.
Start-up Procedure
1. In console storage/head area, power up the boat
by pressing up on
ENGINES
battery switch on the
12VDC distribution panel; switch illuminates.
2. Insert ignition key(s) and rotate to the
ON
position.
The key switch has the following settings:
OFF: No power to engine or
instrumentation.
ACC (accessory): Power to
instrumentation
ON:
Engine power on
START:
(disabled)
3. Ensure THROTTLE AND SHIFT CONTROL lever(s) is in the neutral position and the neutral indicator
is illuminated (see Figure 3.2.1 and Figure 3.3.1).
4. Using the engine trim switch(es) (see Figure 3.3.1), ensure lower unit of engine is in the water.
5. Insert one end of lanyard into engine emergency stop switch (see Figure 3.2.1) and the opposite end attach
to self (operator).
6. Press START/STOP ALL ENGINES button on throttle and shift control (see Figure 3.3.1). The electronic
starting system automatically cranks engine for starting. If engine fails to start, the system stops cranking.
Press start/stop button again until engine starts.
OFF
A
CC
O
N
S
TA
RT
OFF
A
CC
O
N
S
TA
RT
NOTE: Optional 12VDC distribution panel shown is dual
engine with gyroscopic stabilizer.