BOSS
TM
X-POT6+ Operation & Maintenance Manual
(V1.2 September 2017)
Page 4
LIABILIty
All technical information, data and information contained herein are correct at time of
publication. This information is the sum of our current findings and experience to the best
of our knowledge. We reserve the right to make technical changes subject to the future
development of the BOSS™ product referred to in this publication. Hence no rights may
be derived from technical data, descriptions and illustrations. Technical pictures, drawings
and graphs do not necessarily correspond to the actual assemblies or parts as delivered.
Drawings and pictures are not to scale and may contain symbols for simplification.
WARRAnty
Active Period:
Manufacturing defects for 30 months from the date of manufacture or 24
months from the date of commissioning, whichever is sooner.
This warranty covers manufacturing defects only.
Please note that removal of the identification data labels from the equipment will render
the manufacturing warranty null and void.
If the unit is identified with a manufacturing defect then no charge is made for correcting
the defect.
The warranty is conditional upon the following clauses.
1.1 The equipment must be commissioned by a trained, competent engineer or
qualified person, who can verify the integrity of the equipment at that time. The
qualified person must confirm in writing that the equipment is undamaged as a result
of transportation and installation and is fit to begin the warranty period.
1.2 Photographic evidence must be collected at the time of commissioning to verify the
condition of the equipment at that time.
1.3 The equipment must be serviced at least annually, by a trained competent engineer or
qualified person.
1.4 This warranty covers the equipment against manufacturing defects, normal wear
and tear is not covered by this agreement and should form part of a separate service
agreement.
1.5 It may be anticipated that some components will become worn and be identified
for change during the warranty period, the costs associated with the required parts
and associated engineer costs are not covered by this warranty. This will be deemed
as preventative maintenance and will not/does not constitute a manufacturing
defect.
1.6 The equipment must be stored, installed and operated in a frost free area. Damage
as a result of adverse temperature or other adverse environmental conditions will not
be covered by this agreement.
1.7 Any and all non-warranty service visits and non-warranty inspection visits are
chargeable and are not covered by this warranty.
If a defect or problem has arisen as a direct result of the connected system, misuse,
incorrect handling, incorrect installation or incorrect commissioning then any service costs
are chargeable.
If a defect is identified as a manufacturing defect it will be addressed as described above,
additional remedial works as a result of misuse, incorrect handling, incorrect installation or
incorrect commissioning remain chargeable.
