BOSS
TM
X-POT6+ Operation & Maintenance Manual
(V1.2 September 2017)
Page 19
FILteR mAIntenAnCe
1. Disassembly For Filter Replacement
The filter replacement may only be carried out when the X-POT6+ is shut down and the
BOSS™ X-POT6+ has been hydraulically isolated from the main system water pressure and
also electrically isolated from the main system power supply.
The X-POT6+ equipment must be taken out of service and guarded against un-intentional
re-starting until the maintenance work is finished.
NOTE:
•
the safety circuits and data transmissions (if applicable) made or broken
while shutting down could trigger the Bms Alarms or lead to false failure
information.
•
operating instructions for relevant system heating or cooling units must
be observed. to make the hydraulic components safe, isolate the relevant
sections and vents using the relevant drain valves and relieve the pressure.
•
the equipment is to be worked on only when in a safe and cool condition.
•
do not attempt to work on this equipment at elevated temperatures.
•
use of eye/face/hand protectors is required as the eyes or face could
be injured by spraying fluids if the isolating valves have not been closed
properly.
WARNING
This equipment must only be used,
maintained or serviced by trained competent
engineers. If in any doubt please do not
touch this equipment.
For further advice please contact
BSS Industrial or your reseller for additional
information and guidance.
WARNING
This equipment uses Rare Earth Magnets with
a strong magnetic field.
You should not use, service or work in the
close vicinity (30cm / 1ft of this equipment
if you are fitted with a pacemaker or other
electromechanical medical devices.
